preamble attached >>>
ADs updated daily at www.Tdata.com
PROPOSED AD AIRBUS HELICOPTERS: Docket No. FAA-2020-1107; Project Identifier 2019-SW-049-AD.
(a) COMMENTS DUE DATE

    The FAA must receive comments by January 19, 2021.

(b) AFFECTED AIRWORTHINESS DIRECTIVES (ADS)

    None.

(c) APPLICABILITY

    This AD  applies  to  all Airbus Helicopters Model SA330J helicopters,
    certificated in any category.

(d) SUBJECT

    Joint Aircraft System Component (JASC) Code 6320, Main rotor gearbox.

(e) REASON

    This AD was prompted by a  report of failure of a second  stage planet
    gear of the main gear box (MGB). The FAA is issuing this AD to address
    failure of a second stage planet gear of the MGB, which could lead  to
    loss of control of the helicopter.

(f) COMPLIANCE

    Comply  with this  AD within  the compliance  times specified,  unless
    already done.

(g) REQUIREMENTS

    Except as specified in paragraph (h)  of this AD:  Comply with all re-
    quired actions and compliance times specified in,  and  in  accordance
    with, European Union Aviation Safety Agency (EASA) AD 2019-0108, dated
    May 17, 2019 (EASA AD 2019-0108).

(h) EXCEPTIONS TO EASA AD 2019-0108

(1) Where EASA AD 2019-0108 refers to its effective date, this AD requires
    using the effective date of this AD.

(2) The "Remarks" section of EASA AD 2019-0108 does not apply to this AD.

(3) Where EASA AD 2019-0108 refers to flight hours (FH),  this AD requires
    using hours time-in-service.

(4) Although the service information referenced  in  EASA 2019-0108 speci-
    fies to discard certain parts,  this AD does not include that require-
    ment.

(i) SPECIAL FLIGHT PERMIT

    Special flight permits may be issued in accordance with 14 CFR  21.197
    and  21.199  to  operate  the  helicopter  to  a  location  where  the
    helicopter can be modified (if the operator elects to do so), provided
    that no passengers are onboard.

(j) ALTERNATIVE METHODS OF COMPLIANCE (AMOCS)

    The Manager, Rotorcraft Standards Branch,  FAA,  may approve AMOCs for
    this AD.  Send your proposal to: Manager, Rotorcraft Standards Branch,
    FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177;  phone: 817-222-5110;
    email: 9-ASW-FTW-AMOC-Requests@faa.gov.

(k) RELATED INFORMATION

(1) For EASA AD 2019-0108, contact the EASA, Konrad-Adenauer-Ufer 3, 50668
    Cologne, Germany; phone: +49 221 8999 000;  email: ADs@easa.europa.eu;
    internet:  www.easa.europa.eu.  You may find this EASA AD  on the EASA
    website  at  https://ad.easa.europa.eu.  You may view this material at
    the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hill-
    wood Pkwy,  Room 6N-321, Fort Worth, TX 76177.  For information on the
    availability  of this material  at the FAA,  call  817-222-5110.  This
    material may be found in the AD docket on the internet at https://www.
    regulations.gov by searching for and locating Docket No. FAA-2020-1107

(2) For more information about this AD,  contact Mahmood G. Shah, Aviation
    Safety Engineer, Fort Worth ACO Branch, FAA, 10101 Hillwood Pkwy, Fort
    Worth, TX 76177; phone: 817-222-5538; email: mahmood.g.shah@faa.gov.

Issued on November 30, 2020.  Lance T. Gant,  Director,  Compliance & Air-
worthiness Division, Aircraft Certification Service.

DATES: The FAA must receive comments  on this proposed AD  by  January 19,
2021.
PREAMBLE 

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2020-1107; Project Identifier 2019-SW-049-AD]
RIN 2120-AA64

Airworthiness Directives; Airbus Helicopters

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD)
for all Airbus Helicopters Model SA330J helicopters. This proposed AD
was prompted by a report of failure of a second stage planet gear of
the main gear box (MGB). This proposed AD would require replacement of
the MGB particle detector assembly with an improved, elongated MGB
particle detector assembly, as specified in a European Union Aviation
Safety Agency (EASA) AD, which is proposed for incorporation by
reference. The FAA is proposing this AD to address the unsafe condition
on these products.

DATES: The FAA must receive comments on this proposed AD by January 19,
2021.

ADDRESSES: You may send comments, using the procedures found in 14 CFR
11.43 and 11.45, by any of the following methods:

Federal eRulemaking Portal: Go to https://www.regulations.gov. Follow the
instructions for submitting comments.

Fax: 202-493-2251.

Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue SE, Washington, DC 20590.

Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.

For material that will be incorporated by reference (IBR) in this
AD, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany;
phone: +49 221 8999 000; email: ADs@easa.europa.eu; internet:
www.easa.europa.eu. You may find this IBR material on the EASA website
at https://ad.easa.europa.eu. You may view this IBR material at the
FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood
Pkwy, Room 6N-321, Fort Worth, TX 76177. For information on the
availability of this material at the FAA, call 817-222-5110. It is also
available in the AD docket on the internet at https://www.regulations.
gov by searching for and locating Docket No. FAA-2020-1107.

Examining the AD Docket

You may examine the AD docket on the internet at https://www.regulations.
gov by searching for and locating Docket No. FAA-2020-1107;
or in person at Docket Operations between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays. The AD docket contains
this NPRM, any comments received, and other information. The street
address for Docket Operations is listed above. Comments will be
available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Mahmood G. Shah, Aviation Safety
Engineer, Fort Worth ACO Branch, FAA, 10101 Hillwood Pkwy., Fort Worth,
TX 76177; phone: 817-222-5538; email: mahmood.g.shah@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites you to send any written relevant data, views, or
arguments about this proposal. Send your comments to an address listed
under ADDRESSES. Include "Docket No. FAA-2020-1107; Project Identifier
2019-SW-049-AD" at the beginning of your comments. The most helpful
comments reference a specific portion of the proposal, explain the
reason for any recommended change, and include supporting data. The FAA
will consider all comments received by the closing date and may amend
this proposal because of those comments.

Except for Confidential Business Information (CBI) as described in
the following paragraph, and other information as described in 14 CFR
11.35, the FAA will post all comments received, without change, to
https://www.regulations.gov, including any personal information you
provide. The agency will also post a report summarizing each
substantive verbal contact received about this proposal.

Confidential Business Information

CBI is commercial or financial information that is both customarily
and actually treated as private by its owner. Under the Freedom of
Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public
disclosure. If your comments responsive to this NPRM contain commercial
or financial information that is customarily treated as private, that
you actually treat as private, and that is relevant or responsive to
this NPRM, it is important that you clearly designate the submitted
comments as CBI. Please mark each page of your submission containing
CBI as "PROPIN." The FAA will treat such marked submissions as
confidential under the FOIA, and they will not be placed in the public
docket of this NPRM. Submissions containing CBI should be sent to
Mahmood G. Shah, Aviation Safety Engineer, Fort Worth ACO Branch, FAA,
10101 Hillwood Pkwy., Fort Worth, TX 76177; phone: 817-222-5538; email:
mahmood.g.shah@faa.gov. Any commentary that the FAA receives that is
not specifically designated as CBI will be placed in the public docket
for this rulemaking.

Discussion

The EASA, which is the Technical Agent for the Member States of the
European Union, has issued EASA AD 2019-0108, dated May 17, 2019 (EASA
AD 2019-0108) (also referred to as the Mandatory Continuing
Airworthiness Information, or the MCAI), to correct an unsafe condition
for all Airbus Helicopters Model SA330J helicopters.

This proposed AD was prompted by a report of failure of a second
stage planet gear of the MGB on a Model EC225 helicopter. Following a
review of design similarities, it was determined that such an event
might also occur on Model SA330J helicopters. The FAA is proposing this
AD to address failure of a second stage planet gear of the MGB, which
could lead to loss of control of the helicopter. See the MCAI for
additional background information.

Related Service Information Under 1 CFR Part 51

EASA AD 2019-0108 describes procedures for replacement of the MGB
particle detector assembly with an improved, elongated MGB particle
detector assembly.

This material is reasonably available because the interested
parties have access to it through their normal course of business or by
the means identified in the ADDRESSES section.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to the bilateral agreement with the State of Design Authority, the FAA
has been notified of the unsafe condition described in the MCAI
referenced above. The FAA is proposing this AD because the FAA
evaluated all the relevant information and determined the unsafe
condition described previously is likely to exist or develop in other
products of the same type design.

Proposed AD Requirements

This proposed AD would require accomplishing the actions specified
in EASA AD 2019-0108, described previously, as incorporated by
reference, except for any differences identified as exceptions in the
regulatory text of this proposed AD.

Explanation of Required Compliance Information

In the FAA's ongoing efforts to improve the efficiency of the AD
process, the FAA initially worked with Airbus and EASA to develop a
process to use certain EASA ADs as the primary source of information
for compliance with requirements for corresponding FAA ADs. The FAA has
since coordinated with other manufacturers and civil aviation
authorities (CAAs) to use this process. As a result, EASA AD 2019-0108
will be incorporated by reference in the FAA final rule. This proposed
AD would, therefore, require compliance with EASA AD 2019-0108 in its
entirety, through that incorporation, except for any differences
identified as exceptions in the regulatory text of this proposed AD.
Using common terms that are the same as the heading of a particular
section in the EASA AD does not mean that operators need comply only
with that section. For example, where the AD requirement refers to
"all required actions and compliance times," compliance with this AD
requirement is not limited to the section titled "Required Action(s)
and Compliance Time(s)" in the EASA AD. Service information specified
in EASA AD 2019-0108 that is required for compliance with EASA AD 2019-
0108 will be available on the internet at https://www.regulations.gov
by searching for and locating Docket No. FAA-2020-1107 after the FAA
final rule is published.

Costs of Compliance

The FAA estimates that this proposed AD affects 15 helicopters of
U.S. registry. The FAA estimates the following costs to comply with
this proposed AD:

Estimated Costs for Required Actions

Labor cost
Parts cost
Cost per product
Cost on U.S. operators
4 work-hours x $85 per hour = $340
$6,795
$7,135
$107,025

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII: Aviation Programs,
describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: General requirements.
Under that section, Congress charges the FAA with promoting safe flight
of civil aircraft in air commerce by prescribing regulations for
practices, methods, and procedures the Administrator finds necessary
for safety in air commerce. This regulation is within the scope of that
authority because it addresses an unsafe condition that is likely to
exist or develop on products identified in this rulemaking action.

Regulatory Findings

The FAA determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed
regulation:

(1) Is not a "significant regulatory action" under Executive
Order 12866,

(2) Will not affect intrastate aviation in Alaska, and

(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.

The Proposed Amendment

Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive: