DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2020-1036; Project Identifier MCAI-2020-01430-R]
RIN 2120-AA64

Airworthiness Directives; Airbus Helicopters

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD)
for certain Airbus Helicopters Model SA-365N, SA-365N1, AS-365N2, AS
365 N3, EC 155B, and EC155B1 helicopters. This proposed AD was prompted
by the FAA's determination that to improve the process and performance
in collecting metal particles in the main gear box (MGB) certain
existing magnetic plugs (electrical and non-electrical) installed in
the MGB pump intake must be replaced with improved non-electrical
magnetic plugs. This proposed AD would require replacing the existing
magnetic plug with an improved non-electrical magnetic plug, as
specified in a European Aviation Safety Agency (now European Union
Aviation Safety Agency) (EASA) AD, which is proposed for incorporation
by reference. The FAA is proposing this AD to address the unsafe
condition on these products.

DATES: The FAA must receive comments on this proposed AD by January 14,
2021.

ADDRESSES: You may send comments, using the procedures found in 14 CFR
11.43 and 11.45, by any of the following methods:

Federal eRulemaking Portal: Go to https://www.regulations.gov. Follow the
instructions for submitting comments.

Fax: 202-493-2251.

Mail: U.S. Department of Transportation, Docket Operations, M-30, West
Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE,
Washington, DC 20590.

Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.

For material that will be incorporated by reference (IBR) in this
AD, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany;
telephone +49 221 8999 000; email ADs@easa.europa.eu; internet
www.easa.europa.eu. You may find this IBR material on the EASA website
at https://ad.easa.europa.eu. You may view this IBR material at the
FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood
Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the
availability of this material at the FAA, call 817-222-5110. It is also
available in the AD docket on the internet at https://www.regulations.gov
by searching for and locating Docket No. FAA-2020-1036.

Examining the AD Docket

You may examine the AD docket on the internet at https://www.regulations.
gov by searching for and locating Docket No. FAA-2020-1036;
or in person at Docket Operations between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays. The AD docket contains
this NPRM, any comments received, and other information. The street
address for Docket Operations is listed above. Comments will be
available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Mahmood Shah, Aviation Safety
Engineer, Fort Worth ACO Branch, FAA, 10101 Hillwood Pkwy., Fort Worth,
TX 76177; telephone 817-222-5538; email mahmood.g.shah@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites you to send any written relevant data, views, or
arguments about this proposal. Send your comments to an address listed
under ADDRESSES. Include "Docket No. FAA-2020-1036; Project Identifier
MCAI-2020-01430-R" at the beginning of your comments. The most helpful
comments reference a specific portion of the proposal, explain the
reason for any recommended change, and include supporting data. The FAA
will consider all comments received by the closing date and may amend
this proposal because of those comments.

Except for Confidential Business Information (CBI) as described in
the following paragraph, and other information as described in 14 CFR
11.35, the FAA will post all comments received, without change, to
https://www.regulations.gov, including any personal information you
provide. The agency will also post a report summarizing each substantive
verbal contact received about this proposal.

Confidential Business Information

CBI is commercial or financial information that is both customarily
and actually treated as private by its owner. Under the Freedom of
Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public
disclosure. If your comments responsive to this NPRM contain commercial
or financial information that is customarily treated as private, that
you actually treat as private, and that is relevant or responsive to
this NPRM, it is important that you clearly designate the submitted
comments as CBI. Please mark each page of your submission containing
CBI as "PROPIN." The FAA will treat such marked submissions as
confidential under the FOIA, and they will not be placed in the public
docket of this NPRM. Submissions containing CBI should be sent to
Mahmood Shah, Aviation Safety Engineer, Fort Worth ACO Branch, FAA,
10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone 817-222-5538;
email mahmood.g.shah@faa.gov. Any commentary that the FAA receives that
is not specifically designated as CBI will be placed in the public
docket for this rulemaking.

Discussion

The EASA, which is the Technical Agent for the Member States of the
European Union, has issued EASA AD 2018-0176, dated August 21, 2018
(EASA AD 2018-0176) (also referred to as the Mandatory Continuing
Airworthiness Information, or the MCAI), to correct an unsafe condition
for certain Airbus Helicopters Model SA-365N, SA-365N1, AS-365N2, AS
365 N3, EC 155B, and EC155B1 helicopters.

This proposed AD was prompted by the FAA's determination that to
improve the process and performance in collecting metal particles in
the MGB certain existing magnetic plugs (electrical and non-electrical)
installed in the MGB pump intake should be replaced with improved non-
electrical magnetic plugs. The FAA is proposing this AD to address
metal particles causing seizure of the MGB, loss of power to the main
rotor, and subsequent loss of control of the helicopter. See the MCAI
for additional background information.

Related Service Information Under 1 CFR Part 51

EASA AD 2018-0176 describes procedures for replacing the existing
magnetic plug (electrical and non-electrical) installed in the MGB pump
intake with an improved non-electrical magnetic plug. This material is
reasonably available because the interested parties have access to it
through their normal course of business or by the means identified in
the ADDRESSES section.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to the bilateral agreement with the State of Design Authority, the FAA
has been notified of the unsafe condition described in the MCAI
referenced above. The FAA is proposing this AD because the FAA
evaluated all the relevant information and determined the unsafe
condition described previously is likely to exist or develop in other
products of the same type design.

Proposed AD Requirements

This proposed AD would require accomplishing the actions specified
in EASA AD 2018-0176, described previously, as incorporated by
reference, except for any differences identified as exceptions in the
regulatory text of this proposed AD.

Explanation of Required Compliance Information

In the FAA's ongoing efforts to improve the efficiency of the AD
process, the FAA initially worked with Airbus and EASA to develop a
process to use certain EASA ADs as the primary source of information
for compliance with requirements for corresponding FAA ADs. The FAA has
since coordinated with other manufacturers and civil aviation
authorities (CAAs) to use this process. As a result, EASA AD 2018-0176
will be incorporated by reference in the FAA final rule. This proposed
AD would, therefore, require compliance with EASA AD 2018-0176 in its
entirety, through that incorporation, except for any differences
identified as exceptions in the regulatory text of this proposed AD.
Using common terms that are the same as the heading of a particular
section in the EASA AD does not mean that operators need comply only
with that section. For example, where the AD requirement refers to
"all required actions and compliance times," compliance with this AD
requirement is not limited to the section titled "Required Action(s)
and Compliance Time(s)" in the EASA AD. Service information specified
in EASA AD 2018-0176 that is required for compliance with EASA AD 2018-
0176 will be available on the internet at https://www.regulations.gov
by searching for and locating Docket No. FAA-2020-1036 after the FAA
final rule is published.

Interim Action

The FAA considers this proposed AD interim action. If final action
is later identified, the FAA might consider further rulemaking then.

Costs of Compliance

The FAA estimates that this proposed AD affects 52 helicopters of
U.S. registry. The FAA estimates the following costs to comply with
this proposed AD:

Estimated Costs for Required Actions

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII: Aviation Programs,
describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: General requirements.
Under that section, Congress charges the FAA with promoting safe flight
of civil aircraft in air commerce by prescribing regulations for
practices, methods, and procedures the Administrator finds necessary
for safety in air commerce. This regulation is within the scope of that
authority because it addresses an unsafe condition that is likely to
exist or develop on products identified in this rulemaking action.

Regulatory Findings

The FAA determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed
regulation:

(1) Is not a "significant regulatory action" under Executive
Order 12866,

(2) Will not affect intrastate aviation in Alaska, and

(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.

The Proposed Amendment

Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive: