DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2018-0306; Product Identifier 2018-NM-039-AD; Amendment
39-19426; AD 2018-19-25]
RIN 2120-AA64

Airworthiness Directives; Dassault Aviation Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for all
Dassault Aviation Model FALCON 2000 airplanes. This AD was prompted by
a determination that new or more restrictive airworthiness limitations
are necessary. This AD requires revising the maintenance or inspection
program, as applicable, to incorporate new maintenance requirements and
airworthiness limitations. We are issuing this AD to address the unsafe
condition on these products.

DATES: This AD is effective November 2, 2018.
The Director of the Federal Register approved the incorporation by
reference of a certain publication listed in this AD as of November 2,
2018.

ADDRESSES: For service information identified in this final rule,
contact Dassault Falcon Jet Corporation, Teterboro Airport, P.O. Box
2000, South Hackensack, NJ 07606; telephone 201-440-6700; internet
http://www.dassaultfalcon.com. You may view this service information at
the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines,
WA. For information on the availability of this material at the FAA,
call 206-231-3195. It is also available on the internet at http://www.
regulations.gov by searching for and locating Docket No. FAA-2018-0306.

Examining the AD Docket

You may examine the AD docket on the internet at http://www.regulations.
gov by searching for and locating Docket No. FAA-2018-
0306; or in person at Docket Operations between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays. The AD docket contains
this final rule, the regulatory evaluation, any comments received, and
other information. The address for Docket Operations (phone: 800-647-
5527) is U.S. Department of Transportation, Docket Operations, M-30,
West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE,
Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer,
International Section, Transport Standards Branch, FAA, 2200 South
216th St., Des Moines, WA 98198; telephone and fax 206-231-3226.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR
part 39 by adding an AD that would
apply to all Dassault Aviation Model FALCON 2000 airplanes. The NPRM
published in the Federal Register on April 30, 2018 (83 FR 18749). The
NPRM was prompted by a determination that new or more restrictive
airworthiness limitations are necessary. The NPRM proposed to require
revising the maintenance or inspection program, as applicable, to
incorporate new maintenance requirements and airworthiness limitations.
We are issuing this AD to prevent reduced controllability of the
airplane.
The European Aviation Safety Agency (EASA), which is the Technical
Agent for the Member States of the European Union, has issued EASA AD
2017-0236, dated November 30, 2017 (referred to after this as the
Mandatory Continuing Airworthiness Information, or ``the MCAI''), to
correct an unsafe condition for all Dassault Aviation Model FALCON 2000
airplanes. The MCAI states:

The airworthiness limitations for Dassault Falcon 2000
aeroplanes, which are approved by EASA, are currently defined and
published in Aircraft Maintenance Manual (AMM) Airworthiness
Limitations Section (ALS) Chapter 5-40. These instructions have been
identified as mandatory for continued airworthiness.
Failure to accomplish these instructions could result in an
unsafe condition [i.e., reduced controllability of the airplane].
EASA previously issued [EASA] AD 2012-0156 [which corresponds to
FAA AD 2014-03-12, Amendment 39-17749 (79 FR 11693, March 3, 2014)
(``AD 2014-03-12'')], requiring the actions described in Dassault
Falcon 2000 AMM Chapter 5-40 (DGT 113876) at Revision 17.
Since that [EASA] AD was issued, Dassault published Revision 18
of Dassault Falcon 2000 AMM Chapter 5-40 (DGT 113876), containing
new and/or more restrictive maintenance tasks and introducing (among
other changes) the Corrosion Prevention and Control Programme.
For the reason described above, this [EASA] AD retains the
requirements of EASA AD 2012-0156, which is superseded, and requires
accomplishment of the actions specified in Dassault Falcon 2000 AMM
Chapter 5-40 (DGT 113876) at Revision 18 * * * .

You may examine the MCAI in the AD docket on the internet at http://
www.regulations.gov by searching for and locating Docket No. FAA-2018-
0306.

Comments

We gave the public the opportunity to participate in developing
this final rule. We received no comments on the NPRM or on the
determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and
the public interest require adopting this final rule as proposed,
except for minor editorial changes. We have determined that these minor
changes:
Are consistent with the intent that was proposed in the
NPRM for addressing the unsafe condition; and
Do not add any additional burden upon the public than was
already proposed in the NPRM.

Related Service Information Under 1 CFR part 51

Dassault Aviation has issued Chapter 5-40, Airworthiness
Limitations, DGT 113876, Revision 19, dated November 2017, of the
Dassault Falcon 2000 Maintenance Manual. This service information
describes instructions applicable to airworthiness and safe life
limitations. This service information is reasonably available because
the interested parties have access to it through their normal course of
business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 195 airplanes of U.S. registry.
We estimate the following costs to comply with this AD:
We have determined that revising the maintenance or inspection
program takes an average of 90 work-hours per operator, although this
figure may vary from operator to operator. In the past, we have
estimated that this action takes 1 work-hour per airplane. Since
operators incorporate maintenance or inspection program changes for
their affected fleet(s), we have determined that a per-operator
estimate is more accurate than a per-airplane estimate. Therefore, we
estimate the total cost per operator to be $7,650 (90 work-hours x $85
per work-hour).

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII: Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
This AD is issued in accordance with authority delegated by the
Executive Director, Aircraft Certification Service, as authorized by
FAA Order 8000.51C. In accordance with that order, issuance of ADs is
normally a function of the Compliance and Airworthiness Division, but
during this transition period, the Executive Director has delegated the
authority to issue ADs applicable to transport category airplanes and
associated appliances to the Director of the System Oversight Division.

Regulatory Findings

This AD will not have federalism implications under Executive Order
13132. This AD will not have a substantial direct effect on the States,
on the relationship between the national government and the States, or
on the distribution of power and responsibilities among the various
levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive (AD):