preamble attached >>>
ADs updated daily at www.Tdata.com
2018-16-13 ZODIAC SEATS FRANCE (FORMERLY SICMA AERO SEAT): Amendment 39-19353; Docket No. FAA-2017-0688; Product Identifier 2017-NE-23-AD.
(a) EFFECTIVE DATE

    This AD is effective October 26, 2018.

(b) AFFECTED ADS

    None.

(c) APPLICABILITY

(1) This AD applies to all Zodiac Seats France, 537-Series Cabin Attendant
    Seats, part number (P/N) 53701-( )( )-( ) ( ) ( ).

(2) These  appliances  are  installed  on,  but not limited to,  Avions de
    transport regional (ATR) 42 and ATR 72 airplanes of U.S. registry.

(d) SUBJECT

    Joint Aircraft System Component  (JASC)  2500  Code,  Cabin Equipment/
    Furnishings.

(e) UNSAFE CONDITION

    This AD  was prompted  by operator  reports that  safety belt wear was
    found at the  attachment to the  cabin attendant seat.  We are issuing
    this  AD  to prevent  failure  of these  attendant  seats. The  unsafe
    condition, if not  addressed, could result  in possible injury  to the
    seat occupant.

(f) COMPLIANCE

    Comply  with this  AD within  the compliance  times specified,  unless
    already done.

(g) REQUIRED ACTIONS

    Within 720 flight cycles after the effective date of this AD,  inspect
    safety belt webbing, modify and re-mark each affected cabin  attendant
    seat  using  Zodiac Seats France  Service  Information  Letter 537-01,
    dated July 31, 2015,  and the Accomplishment Instructions,  paragraphs
    2.A. through 2.B.,  of Zodiac Seats France Service Bulletin No. 537-25
    -003, Revision 1, dated August 29, 2016.

(h) INSTALLATION PROHIBITION

    After  the effective  date of  this AD,  do not  install any  affected
    Zodiac Seats France cabin attendant seat on any aircraft.

(i) ALTERNATIVE METHODS OF COMPLIANCE (AMOCS)

(1) The  Manager,  Boston  ACO Branch,  FAA,  has the authority to approve
    AMOCs for this AD, if requested  using the procedures found in 14  CFR
    39.19. In  accordance with  14 CFR  39.19, send  your request  to your
    principal  inspector  or  local  Flight Standards District Office,  as
    appropriate. If  sending information  directly to  the manager  of the
    Boston ACO Branch, send it  to the attention of the  person identified
    in paragraph (j)(1) of this AD.

(2) Before using any approved AMOC,  notify your appropriate principal in-
    spector,  or lacking a principal inspector,  the manager of  the local
    flight standards district office/certificate holding district office.

(j) RELATED INFORMATION

(1) For more information about this AD,  contact  Dorie Resnik,  Aerospace
    Engineer,  Boston ACO Branch,  FAA,  1200 District Avenue, Burlington,
    MA, 01803; phone: 781-238-7693; fax: 781-238-7199; email: dorie.resnik
    @faa.gov.

(2) Refer  to  European Aviation Safety Agency (EASA) AD 2016-0163,  dated
    August 10, 2016, for more information.  You may examine the EASA AD in
    the  AD  docket  on  the  Internet  at  http://www.regulations.gov  by
    searching for and locating Docket No. FAA-2017-0688.

(k) MATERIAL INCORPORATED BY REFERENCE

(1) The Director of the Federal Register  approved  the  incorporation  by
    reference (IBR) of  the service information  listed in this  paragraph
    under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use  this service information as applicable to do the actions
    required by this AD, unless the AD specifies otherwise.

(i) Zodiac Seats France Service Bulletin No. 537-25-003, Revision 1, dated
    August 29, 2016.

(ii) Zodiac Seats France Service Information Letter 537-01, dated July 31,
     2015.

(3) For service information identified  in this AD,  contact  Zodiac Seats
    France,  Rue Robert Marechal Senior B.P. 69,  36100 Issoudun,  France;
    phone: +33 (0) 9 70 83 08 30;fax: +33 (0) 2 54 03 39 00;email: zs.tac@
    zodiacaerospace.com;internet: http://www.services.zodiacaerospace.com.

(4) You  may  view  this  service information  at FAA,  Engine & Propeller
    Standards Branch, 1200 District Avenue, Burlington, MA, 01803. For in-
    formation on the availability of this material at the FAA,  call  781-
    238-7759.

(5) You  may  view  this  service  information  that  is  incorporated  by
    reference at the National Archives and Records Administration  (NARA).
    For information on the availability of this material at NARA, call 202
    -741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-
    locations.html.

Issued in Burlington, Massachusetts on September 7, 2018. Robert J Ganley,
Manager,  Engine  and  Propeller  Standards Branch, Aircraft Certification
Service

FOR FURTHER INFORMATION CONTACT: Dorie Resnik, Aerospace Engineer,  Boston
ACO Branch, FAA, 1200 District Avenue, Burlington, MA, 01803;  phone: 781-
238-7693; fax: 781-238-7199; email: dorie.resnik@faa.gov.
PREAMBLE 

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2017-0688; Product Identifier 2017-NE-23-AD; Amendment
39-19353; AD 2018-16-13]
RIN 2120-AA64

Airworthiness Directives; Zodiac Seats France, Cabin Attendant Seats

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for certain
Zodiac Seats France, 537-Series Cabin Attendant Seats. This AD was
prompted by operator reports that safety belt wear was found at the
attachment to the cabin attendant seat. This AD requires inspecting the
safety belt webbing, and modifying and re-marking each affected cabin
attendant seat. We are issuing this AD to address the unsafe condition
on these products.

DATES: This AD is effective October 26, 2018.
The Director of the Federal Register approved the incorporation by
reference of certain publications listed in this AD as of October 26,
2018.

ADDRESSES: For service information identified in this final rule,
contact Zodiac Seats France, Rue Robert Marechal Senior B.P. 69, 36100
Issoudun, France; phone: +33 (0) 9 70 83 08 30; fax: +33 (0) 2 54 03 39
00; email: zs.tac@zodiacaerospace.com; internet: http://www.services.
zodiacaerospace.com. You may view this service information
at the FAA, Engine & Propeller Standards Branch, 1200 District Avenue,
Burlington, MA, 01803. For information on the availability of this
material at the FAA, call 781-238-7759. It is also available on the
internet at http://www.regulations.gov by searching for and locating
Docket No. FAA-2017-0688.

Examining the AD Docket

You may examine the AD docket on the internet at http://www.regulations.gov
by searching for and locating Docket No. FAA-2017-
0688; or in person at Docket Operations between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays. The AD docket contains
this final rule, the mandatory continuing airworthiness information
(MCAI), the regulatory evaluation, any comments received, and other
information. The address for Docket Operations (phone: 800-647-5527) is
U.S. Department of Transportation, Docket Operations, M-30, West
Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE,
Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Dorie Resnik, Aerospace Engineer,
Boston ACO Branch, FAA, 1200 District Avenue, Burlington, MA 01803;
phone: 781-238-7693; fax: 781-238-7199; email: dorie.resnik@faa.gov.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR
part 39 by adding an AD that would apply to certain Zodiac Seats
France, 537-Series Cabin Attendant Seats. The NPRM published in the
Federal Register on December 11, 2017 (82 FR 58137). The NPRM was
prompted by operator reports that safety belt wear was found at the
attachment to the cabin attendant seat. The NPRM proposed to require
inspecting the safety belt webbing, and modifying and re-marking each
affected cabin attendant seat. We are issuing this AD to address the
unsafe condition on these products.
The European Aviation Safety Agency (EASA), which is the Technical
Agent for the Member States of the European Community, has issued EASA
AD 2016-0163, dated August 10, 2016 (referred to after this as ``the
MCAI''), to address the unsafe condition on these products. The MCAI
states:

Cases were reported by operators of finding safety belt worn out
at the attachment to the cabin attendant seat. This kind of belt
damage is due to chafing between the belt and the surrounding metal
lap belt fitting of the cabin attendant seat. This condition, if not
detected and corrected, could lead to failure of the attendant seat
to perform its intended function, possibly resulting in injury to
the seat occupant. Prompted by these occurrences, Zodiac Seats
France issued Service Bulletin (SB) No. 537-25-003, providing
instructions to modify the affected seats. For the reason described
above, this [EASA] AD requires a modification of the seat pan shaft
by installing new seat pan spacers, and subsequent re-identification
with a new P/N.

You may obtain further information by examining the MCAI in the AD
docket on the internet at http://www.regulations.gov by searching for
and locating Docket No. FAA-2017-0688.

Comments

We gave the public the opportunity to participate in developing
this final rule. We received no comments on the NPRM or on the
determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and
the public interest require adopting this final rule as proposed except
for minor editorial changes. We have determined that these minor
changes:
Are consistent with the intent that was proposed in the
NPRM for addressing the unsafe condition; and
Do not add any additional burden upon the public than was
already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

We reviewed Zodiac Seats France Service Bulletin (SB) No. 537-25-
003, Revision 1, dated August 29, 2016. The SB describes procedures for
installing an anti-rotation device on the seat pan shaft to limit the
rotation of the safety belt. We also reviewed Zodiac Seats France
Service Information Letter (SIL) 537-01, dated July 31, 2015. The SIL
provides details to identify if the safety belt must be removed and
replaced and provides instructions on safety belt storage to avoid this
premature wear. This service information is reasonably available
because the interested parties have access to it through their normal
course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 55 seat assemblies installed on,
but not limited to, Avions de transport regional (ATR) 42 and ATR 72
airplanes of U.S. registry.
We estimate the following costs to comply with this AD:

Estimated Costs

Action Labor cost Parts cost Cost per product Cost on U.S. operators
Seat inspection and modification 0.5 work-hours x $85 per hour = $42.50 $300 $342.50 $18,837.50

According to the manufacturer, some of the costs of this AD may be
covered under warranty, thereby reducing the cost impact on affected
individuals. We do not control warranty coverage for affected
individuals. As a result, we have included all costs in our cost
estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII: Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
This AD is issued in accordance with authority delegated by the
Executive Director, Aircraft Certification Service, as authorized by
FAA Order 8000.51C. In accordance with that order, issuance of ADs is
normally a function of the Compliance and Airworthiness Division, but
during this transition period, the Executive Director has delegated the
authority to issue ADs applicable to engines, propellers, and
associated appliances to the Manager, Engine and Propeller Standards
Branch, Policy and Innovation Division.

Regulatory Findings

This AD will not have federalism implications under Executive Order
13132. This AD will not have a substantial direct effect on the States,
on the relationship between the national government and the States, or
on the distribution of power and responsibilities among the various
levels of government.
For the reasons discussed above, I certify this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive (AD):