preamble attached >>>
ADs updated daily at www.Tdata.com
PROPOSED AD BOMBARDIER, INC.: Docket No. FAA-2018-0449; Product Identifier 2018-NM-042-AD.
(a) COMMENTS DUE DATE

    We must receive comments by July 9, 2018.

(b) AFFECTED ADS

    None.

(c) APPLICABILITY

    This  AD  applies to Bombardier, Inc., Model DHC-8-400, -401, and -402
    airplanes, certificated in any category,  serial numbers 4001 and sub-
    sequent.

(d) SUBJECT

    Air Transport Association (ATA) of America Code 27, Flight controls.

(e) REASON

    This AD  was prompted  by a  report of  uncommanded deployment  of the
    ground spoilers when the power levers were advanced for takeoff, which
    was  caused by  faulty switches  in the  power lever  module.  We  are
    issuing this AD to address faulty switches in the power lever  module,
    which could result  in uncommanded deployment  of the ground  spoilers
    and a possible runway excursion.

(f) COMPLIANCE

    Comply  with this  AD within  the compliance  times specified,  unless
    already done.

(g) REVISION OF MAINTENANCE OR INSPECTION PROGRAM

    Within 30 days after the effective date of this AD: Revise the mainte-
    nance or inspection program, as applicable,  to incorporate the infor-
    mation specified  in Certification Maintenance Requirements (CMR) Task
    276000-110 of Q400 Dash 8  (Bombardier)  Temporary Revision  ALI-0173,
    dated  March 14, 2017,  to  Section  1-27,  Certification  Maintenance
    Requirements of the Maintenance Requirements Manual (MRM)  Part 2,  of
    Product Support Manual (PSM) 1-84-7.

(h) INITIAL COMPLIANCE TIME

    The  initial  compliance  time  for  doing  the  CMR  Task  276000-110
    specified in  paragraph (g)  of this  AD is  within 8,000 flight hours
    after the effective date of this AD.

(i) NO ALTERNATIVE ACTIONS OR INTERVALS

    After  the  maintenance  or inspection  program  has  been revised  as
    required by paragraph  (g) of this  AD, no alternative  actions (e.g.,
    inspections) or intervals may be used unless the actions or  intervals
    are  approved  as  an  alternative  method  of  compliance  (AMOC)  in
    accordance with the procedures  specified in paragraph (j)(1)  of this
    AD.

(j) OTHER FAA AD PROVISIONS

    The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs):  The Manager,  New York ACO
    Branch,  FAA,  has  the authority  to approve  AMOCs for  this AD,  if
    requested using the  procedures found in  14 CFR 39.19.  In accordance
    with 14 CFR  39.19, send your  request to your  principal inspector or
    local Flight  Standards District  Office, as  appropriate. If  sending
    information directly to the manager of the certification office,  send
    it to ATTN: Program  Manager, Continuing Operational Safety,  FAA, New
    York ACO Branch, 1600 Stewart  Avenue, Suite 410, Westbury, NY  11590;
    telephone 516-228-7300;  fax 516-794-5531.  Before using  any approved
    AMOC,  notify  your  appropriate  principal  inspector,  or  lacking a
    principal  inspector,  the  manager  of  the  local  flight  standards
    district office/certificate holding district office.

(2) Contacting the Manufacturer:  For any requirement in this AD to obtain
    corrective  actions   from  a   manufacturer,  the   action  must   be
    accomplished using  a method  approved by  the Manager,  New York  ACO
    Branch, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier,
    Inc.'s TCCA  Design Approval  Organization (DAO).  If approved  by the
    DAO, the approval must include the DAO-authorized signature.

(k) RELATED INFORMATION

(1) Refer   to   Mandatory  Continuing  Airworthiness  Information  (MCAI)
    Canadian Airworthiness Directive CF-2017-35,  dated November 29, 2017,
    for related information. This  MCAI may be found  in the AD docket  on
    the  internet  at  http://www.regulations.gov  by  searching  for  and
    locating Docket No. FAA-2018-0449.

(2) For more information about this AD,  contact John P. DeLuca, Aerospace
    Engineer, Avionics and Administrative Services Section, FAA,  New York
    ACO Branch,  1600 Stewart Avenue, Suite 410, Westbury, NY 11590; tele-
    phone 516-228-7369; fax 516-794-5531; email 9-avs-nyaco-cos@faa.gov.

(3) For  service information identified  in this AD,  contact  Bombardier,
    Inc.,  Q-Series Technical Help Desk,  123 Garratt Boulevard,  Toronto,
    Ontario M3K 1Y5, Canada;  telephone 416-375-4000; fax 416-375-4539; e-
    mail thd.qseries@aero.bombardier.com;  internet http://www.bombardier.
    com.  You may  view this  service information  at the  FAA,  Transport
    Standards Branch, 2200 South 216th St, Des Moines, WA. For information
    on the availability of this material at the FAA, call 206-231-3195.

Issued in Des Moines, Washington, on May 15, 2018. Dionne Palermo,  Acting
Director, System Oversight Division, Aircraft Certification Service.

DATES: We must receive comments on this proposed AD by July 9, 2018.
PREAMBLE 

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2018-0449; Product Identifier 2018-NM-042-AD]
RIN 2120-AA64

Airworthiness Directives; Bombardier, Inc., Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: We propose to adopt a new airworthiness directive (AD) for
certain Bombardier, Inc., Model DHC-8-400 series airplanes. This
proposed AD was prompted by a report of uncommanded deployment of the
ground spoilers when the power levers were advanced for takeoff, which
was caused by faulty switches in the power lever module. This proposed
AD would require revising the maintenance or inspection program, as
applicable. We are proposing this AD to address the unsafe condition on
these products.

DATES: We must receive comments on this proposed AD by July 9, 2018.

ADDRESSES: You may send comments, using the procedures found in 14 CFR
11.43 and 11.45, by any of the following methods:

Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the
instructions for submitting comments.

Fax: 202-493-2251.

Mail: U.S. Department of Transportation, Docket Operations, M-30, West
Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE,
Washington, DC 20590.

Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.

For service information identified in this NPRM, contact
Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard,
Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-
4539; email thd.qseries@aero.bombardier.com; internet http://www.
bombardier.com. You may view this service information at the FAA,
Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For
information on the availability of this material at the FAA, call 206-
231-3195.

Examining the AD Docket

You may examine the AD docket on the internet at http://www.regulations.
gov by searching for and locating Docket No. FAA-2018-0449;
or in person at the Docket Management Facility between 9 a.m. and
5 p.m., Monday through Friday, except Federal holidays. The AD docket
contains this NPRM, the regulatory evaluation, any comments received,
and other information. The street address for the Docket Operations
office (telephone 800-647-5527) is in the ADDRESSES section. Comments
will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: John P. DeLuca, Aerospace Engineer,
Avionics and Administrative Services Section, FAA, New York ACO Branch,
1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-
7369; fax 516-794-5531; email 9-avs-nyaco-cos@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or
arguments about this proposal. Send your comments to an address listed
under the ADDRESSES section. Include "Docket No. FAA-2018-0449;
Product Identifier 2018-NM-042-AD" at the beginning of your comments.
We specifically invite comments on the overall regulatory, economic,
environmental, and energy aspects of this NPRM. We will consider all
comments received by the closing date and may amend this NPRM based on
those comments.

We will post all comments we receive, without change, to http://www.
regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this NPRM.

Discussion

Transport Canada Civil Aviation (TCCA), which is the aviation
authority for Canada, has issued Canadian Airworthiness Directive CF-
2017-35, dated November 29, 2017 (referred to after this as the
Mandatory Continuing Airworthiness Information, or "the MCAI"), to
correct an unsafe condition for certain Bombardier, Inc., Model
DHC-8-400 series airplanes. The MCAI states:

There has been an incident of uncommanded deployment of the
ground spoilers when the power levers were advanced for take-off.
The warning horn sounded and the pilot rejected the take-off. The
subsequent investigation determined the root cause of the spoiler
deployment was faulty switches in the power lever module. An
uncommanded deployment of the ground spoilers may lead to a runway
excursion.

This [Canadian] AD mandates the incorporation of a new
Certification Maintenance Requirement (CMR) task to check the ground
spoiler switches in the power lever module.

Required actions include revising the maintenance or inspection
program, as applicable. You may examine the MCAI in the AD docket on
the internet at http://www.regulations.gov by searching for and
locating Docket No. FAA-2018-0449.

Related Service Information Under 1 CFR Part 51

Bombardier has issued Q400 Dash 8 (Bombardier) Temporary Revision
ALI-0173, dated March 14, 2017, to Section 1-27, Certification
Maintenance Requirements of the Maintenance Requirements Manual (MRM)
Part 2, of Product Support Manual (PSM) 1-84-7. This service
information describes CMR Task 276000-110, "Operational Check of the
Ground Spoiler Switches in the Power Lever Module." This service
information is reasonably available because the interested parties have
access to it through their normal course of business or by the means
identified in the ADDRESSES section.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with the State of Design Authority, we have
been notified of the unsafe condition described in the MCAI and service
information referenced above. We are proposing this AD because we
evaluated all pertinent information and determined an unsafe condition
exists and is likely to exist or develop on other products of the same
type design.

Costs of Compliance

We estimate that this proposed AD affects 86 airplanes of U.S.
registry.

We estimate the following costs to comply with this proposed AD:

We have determined that revising the maintenance or inspection
program takes an average of 90 work-hours per operator, although we
recognize that this number may vary from operator to operator. In the
past, we have estimated that this action takes 1 work-hour per
airplane. Since operators incorporate maintenance or inspection program
changes for their affected fleet(s), we have determined that a per-
operator estimate is more accurate than a per-airplane estimate.
Therefore, we estimate the total cost per operator to be $7,650 (90
work-hours x $85 per work-hour).

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII: Aviation Programs,
describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: "General
requirements." Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.

This proposed AD is issued in accordance with authority delegated
by the Executive Director, Aircraft Certification Service, as
authorized by FAA Order 8000.51C. In accordance with that order,
issuance of ADs is normally a function of the Compliance and
Airworthiness Division, but during this transition period, the
Executive Director has delegated the authority to issue ADs applicable
to transport category airplanes to the Director of the System Oversight
Division.

Regulatory Findings

We determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed
regulation:

1. Is not a "significant regulatory action" under Executive Order
12866;

2. Is not a "significant rule" under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979);

3. Will not affect intrastate aviation in Alaska; and

4. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.

The Proposed Amendment

Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES


1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive (AD):