DEPARTMENT OF TRANSPORTATION
FEDERAL AVIATION ADMINISTRATION
14 CFR Part 39
[Docket No. FAA-2010-0805; Directorate Identifier 2010-NM-042-AD] RIN
2120-AA64
AIRWORTHINESS DIRECTIVES; Bombardier, Inc. Model DHC-8-300 Series Air-
planes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
--------------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the
products listed above. This proposed AD results from mandatory continuing
airworthiness information (MCAI) originated by an aviation authority of
another country to identify and correct an unsafe condition on an aviation
product. The MCAI describes the unsafe condition as: Several cases of
aileron terminal quadrant support brackets that were manufactured using
sheet metal have been found cracked on DHC-8 Series 300 aircraft.
Investigation revealed that the failure of the support bracket was due to
fatigue. Failure of the aileron terminal quadrant support bracket could
result in an adverse reduction of aircraft roll control. These conditions
could result in loss of control of the airplane. The proposed AD would
require actions that are intended to address the unsafe condition
described in the MCAI.
DATES: We must receive comments on this proposed AD by October 12, 2010.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the
instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West
Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE.,
Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30,
West Building Ground Floor, Room W12-40, 1200 New Jersey Avenue, SE.,
Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except
Federal holidays.
For service information identified in this proposed AD, contact
Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Qu[eacute]bec
H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; e-mail
thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com. You
may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington.
For information on the availability of this material at the FAA, call 425
-227-1221.
EXAMINING THE AD DOCKET
You may examine the AD docket on the Internet at http://
www.regulations.gov; or in person at the Docket Operations office between
9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD
docket contains this proposed AD, the regulatory evaluation, any comments
received, and other information. The street address for the Docket
Operations office (telephone (800) 647-5527) is in the ADDRESSES section.
Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Craig Yates, Aerospace Engineer, Airframe
and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certificat-
ion Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, New York
11590; telephone (516) 228-7355; fax (516) 794-5531.
SUPPLEMENTARY INFORMATION:
COMMENTS INVITED
We invite you to send any written relevant data, views, or arguments about
this proposed AD. Send your comments to an address listed under the
ADDRESSES section. Include "Docket No. FAA-2010-0805; Directorate
Identifier 2010-NM-042-AD" at the beginning of your comments. We specific-
ally invite comments on the overall regulatory, economic, environmental,
and energy aspects of this proposed AD. We will consider all comments
received by the closing date and may amend this proposed AD based on those
comments.
We have lengthened the 30-day comment period for proposed ADs that address
MCAI originated by aviation authorities of other countries to provide
adequate time for interested parties to submit comments. The comment
period for these proposed ADs is now typically 45 days, which is
consistent with the comment period for domestic transport ADs.
We will post all comments we receive, without change, to http://
www.regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this proposed AD.
DISCUSSION
Transport Canada Civil Aviation (TCCA), which is the aviation authority
for Canada, has issued Canadian Airworthiness Directive CF-2009-45, dated
December 11, 2009 (referred to after this as "the MCAI"), to correct an
unsafe condition for the specified products. The MCAI states:
Several cases of aileron terminal quadrant support brackets that were
manufactured using sheet metal have been found cracked on DHC-8 Series 300
aircraft. Investigation revealed that the failure of the support bracket
was due to fatigue. Failure of the aileron terminal quadrant support
bracket could result in an adverse reduction of aircraft roll control.
This directive mandates the replacement of the aileron terminal quadrant
support bracket with a new and improved machined part.
These conditions could result in loss of control of the airplane. The
required actions include installing new aileron input quadrant support
brackets. You may obtain further information by examining the MCAI in the
AD docket.
RELEVANT SERVICE INFORMATION
Bombardier has issued Service Bulletin 8-57-43, Revision B, dated October
7, 2009. The actions described in this service information are intended to
correct the unsafe condition identified in the MCAI.
FAA'S DETERMINATION AND REQUIREMENTS OF THIS PROPOSED AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant to
our bilateral agreement with the State of Design Authority, we have been
notified of the unsafe condition described in the MCAI and service
information referenced above. We are proposing this AD because we
evaluated all pertinent information and determined an unsafe condition
exists and is likely to exist or develop on other products of the same
type design.
DIFFERENCES BETWEEN THIS AD AND THE MCAI OR SERVICE INFORMATION
We have reviewed the MCAI and related service information and, in general,
agree with their substance. But we might have found it necessary to use
different words from those in the MCAI to ensure the AD is clear for U.S.
operators and is enforceable. In making these changes, we do not intend to
differ substantively from the information provided in the MCAI and related
service information.
We might also have proposed different actions in this AD from those in the
MCAI in order to follow FAA policies. Any such differences are highlighted
in a Note within the proposed AD.
COSTS OF COMPLIANCE
Based on the service information, we estimate that this proposed AD would
affect about 13 products of U.S. registry. We also estimate that it would
take about 72 work-hours per product to comply with the basic requirements
of this proposed AD. The average labor rate is $85 per work-hour. Required
parts would cost about $1,080 per product. Where the service information
lists required parts costs that are covered under warranty, we have
assumed that there will be no charge for these costs. As we do not control
warranty coverage for affected parties, some parties may incur costs
higher than estimated here. Based on these figures, we estimate the cost
of the proposed AD on U.S. operators to be $93,600, or $7,200 per product.
AUTHORITY FOR THIS RULEMAKING
Title 49 of the United States Code specifies the FAA's authority to issue
rules on aviation safety. Subtitle I, section 106, describes the authority
of the FAA Administrator. "Subtitle VII: Aviation Programs," describes in
more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in "Subtitle
VII, Part A, Subpart III, Section 44701: General requirements." Under that
section, Congress charges the FAA with promoting safe flight of civil
aircraft in air commerce by prescribing regulations for practices,
methods, and procedures the Administrator finds necessary for safety in
air commerce. This regulation is within the scope of that authority
because it addresses an unsafe condition that is likely to exist or devel-
op on products identified in this rulemaking action.
REGULATORY FINDINGS
We determined that this proposed AD would not have federalism implications
under Executive Order 13132. This proposed AD would not have a substantial
direct effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and responsib-
ilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a "significant regulatory action" under Executive Order 12866;
2. Is not a "significant rule" under the DOT Regulatory Policies and Proc-
edures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a
substantial number of small entities under the criteria of the Regul-
atory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with
this proposed AD and placed it in the AD docket.
LIST OF SUBJECTS IN 14 CFR PART 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference,
Safety.
THE PROPOSED AMENDMENT
Accordingly, under the authority delegated to me by the Administrator, the
FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
SEC. 39.13 [AMENDED]
2. The FAA amends Sec. 39.13 by adding the following new AD: